It is interesting for many people as to how some medical preparations are used. Though we are used to being prescribed medicine and tablet forms there are many treatments that are administered by injection. In this guide, we look at where to inject Follistatin 344 peptide plus other interesting facts on bio peptide follistatin 344. For those in the research and science industry, and who want a reliable source to buy Follistatin 344 click here today!
Follistatin 344 Dosage – Preparation and Injection
For those familiar with the research peptide follistatin muscle peptide, you will know it comes in powder and liquid form, which means it will need to be reconstructed with bacteriostatic water. This is a job that needs care and caution. One of the most important practices is when you add the bacteriostatic water to either the powder or liquid. The key is to add the water slowly into the vial, similar to a drip-feed. Many who are familiar with this process tilt the vial at a 45-degree angle and allow the water to trickle and mix with the powder. Then when the two meet it is best to let them melt together carefully. Using follistatin liquid is easier as the water is easier to add.
Steps to Follistatin 344 half-life
To reconstitute the peptide Follistatin 344 these are the steps you should follow:
- Using an alcohol wipe clean down the bacteriostatic water and follistatin vial and prepare the needle
- Carefully perforate the vial of water and draw enough water to provide the product in the vial. A guide is about 0.5 ml per mg of powder peptide.
- Perforate the follistatin vial and gently allow the water to slowly run down the side and let it meet with the powder to make sure they combine carefully. This should be like a melting process.
- After the two are blended, it is vital to use or store them according to instructions from the supplier.
- Unreconstituted peptide needs to be stored at minus 20 degrees and kept away from sunlight, but it can be kept at room temperature for several weeks without losing its structure.
- The reconstituted peptide should always be kept at minus 20 degrees.
- The best place where to inject Follistatin 344 is either intramuscularly straight into the muscle or subcutaneously the fat layer under the skin.
A Guide to Follistatin
Follistatin is involved in many different regulatory systems, many of which are due to the affinity for Activin. For example, follistatin is an important regulator in the ovaries in women, testicles in men, the pituitary gland, the liver, and the vascular system. There are several types of follistatin, all of which vary in length (288, 303, and 344 amino acids). But only follistatin 344 appears to be active in muscle cells.
Study so far…
In a 2008 animal study, mice were injected with various myostatin blockers and follistatin 344. While mice that were not injected with myostatin blockers gradually became weaker and lost muscle mass over a period of 2 years. The other mice that were injected with myostatin blockers were able to continuously increase their muscle mass over the course of two years. Those mice that were injected with Follistatin 344 clearly had the most muscle gain. It is interesting to note that a single injection when the mice were four weeks old was sufficient.
The actual effect of Follistatin 344 is based on the fact that it complexes with myostatin and thus changes its structure, which cancels the signaling effect of myostatin. Follistatin 344 is produced via genetic modification of e.coli. The peptide Follistatin-344 is currently being studied for the treatment of muscular dystrophy.
Follistatin 344 Dosage
Follistatin 344 dosage is usually injected intramuscularly or intravenously at a dose of 50-100mcg per day for approximately 10-30 days. Higher doses up to 300mcg per day are also observed but do not lead to better results.
Experience has shown that the results are very disappointing anyway. Almost all users report no significant muscle growth while taking it. This is either because the research results from animal studies are not transferable to humans. Or because only ineffective preparations were used.
Side effects
From official studies no Follistatin 33 specific side effects are known, however, the blocking of myostatin is generally accompanied by damage to the joints. However, users have reported various side effects, such as swollen wrists, nosebleeds, bleeding gums, and vasodilation, but subside after time.
Follistatin 344 has been co-administered with a virus (Ade-no-Associated Virus / AAV) in many studies. Now, this combination is also available from reputable Research Chemicals Shops. Users of this mix report flu-like symptoms over a period of approximately one hour after the injection.
If you have enjoyed our guide on where to inject follistatin 344, and want to know more about this peptide read this Wikki link.